Skip to content

Plumbing in Otford: stop a dripping tap or running toilet

By PRG Property Services
5 Nov 20262 min read
A polished chrome single lever tap on a clean white bathroom basin with a pop-up waste, below a frosted window

Start by closing the small isolation valve on the pipe directly under the leaking tap or toilet. It stops the leak without turning off water to the whole house. Use a flat head screwdriver. The water is on when the slot follows the pipe, and off after a quarter turn so the slot sits across it. If the leak carries on, turn the water off at the stop tap instead.

A running toilet is easy to miss. Listen for a constant trickle from the cistern when nobody has flushed, or look for ripples on the water in the pan. To check, put a few drops of food colouring in the cistern and leave it for a while. If colour appears in the pan, it is leaking. The cause is usually a failed seal on the flush valve or fill valve.

A dripping tap usually has a rubber washer that has cracked, gone brittle or clogged with limescale. On a single lever tap, a worn or clogged cartridge can cause the drip.

Acting early saves water, because a leaking toilet can waste between two hundred and four hundred litres a day. Call me if a tap is badly damaged or you are unsure what is causing the drip. I'm Lubomir at PRG Property Services, and I sort dripping taps and running toilets across Otford. Get in touch through my plumbing page.

Planning a job like this? Tell us what you need.